Hi Kelly,
Thank you for you interest. Response has been overwhelming, but I will try to
shed some light on the subject.
The intent of the original post was in response to a question regarding
replating a housing, and their search for a way to microfinish it.
In the instances of refurbishment due to wear, a replacement coating is
specified.
Ceramic is one choice, there are many, and the choice is determined on a case
by case basis after considering
the desired outcome and use. Chrome Carbide, tungsten carbide, and some new
proprietary compounds that offer glimpses of million mile motors with ZERO
wear.
In cases where enhanced performance of new parts is desired an additional
coating can be utilized.
These instances include sidehousings and rotors coated with coatings that
enhance lubricity, such as moly.
Costs are widely varying, based on materials, quantity, and application.
Ball park prices are between $300 and $1500.
These are subject to change.
It is our intent to offer these coatings a a price less than replacement
housings would cost, and offer improved performance over new ones.
Since these engines are used in experimentel aircraft, are there FAA
regulations regarding modifications done post-manufacture? There are some
questions we would need answered before we could attempt to determine costs.
In the original forum, the application was a turbo charged automotive engine.
RPM and bost levels would vary.
Aircraft engines tend to run at constant RPM and load. Different coatings
would be needed for different uses.
It is our intent to offer these coatings a a price less than replacement
rotors would cost.
On a modified or racing engine, labor intensive modifications are common.
The ability to recoat them during their lifecycle allows costs to drop when
not having to pay labor to port or modify the new set, consistancy goes up,
expenses go down.
I hope this answered some of your questions, as I have stated elsewhere, this
is new to market, the result of many years of planning and just coming to
fruition. The future is here, finally.
Kindest regards,
Cliff Roberts
Metal Solutions Corp
Snip
Cliff,
We have no restrictions by the FAA regarding our
use of auto engines in experimental A/C. We can use any
parts or procedures that we are willing to bet our lives
on. Please keep us appraised as things develop as I know
many of this group are potential customers.
Best Regards
Kelly Troyer
Kelly Troyer
Dyke Delta/13B Rotary Power
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org