Subject: Wall behind rads
From: ACRE NL
Date: 8/7/2002, 10:35 PM


 What this K&M graph fig 12-16 is saying is... if you have a wall behind
your
 rad that is less than half the height of the rad away from the
 rad you are paying a severe penalty in cooling flow.
 In other words a 20 inch high rad must be ten inches in front
 of the firewall. Here is a picture of the rad installation
 in the Power Sport RV6. Draw your own conclusions.
 Are you listening Keith and Ray?

Paul,
Interesting curves -- I received the electronic file of chapter 12 today, and
it is interesting reading.

With your rad under the engine, with the sloping oil pan only a few (3?)
inches away from the back of the radiator, won't that cause a flow
maldistribution also?

Bill Schertz
KIS Cruiser #4045

I hope you taperd your oil pan. Opps I see you did not. First
is yours. Second is mine.

Not to worry just make your rad a bit wider and move it as low as
you can get it.

Paul Lamar


Not to worry too much Bill. Unlike the test box on the Dodge and
the Power Sport mount on the firewall the air out of the back
side of the Kis rad can go around the sides of the pan. It is not
as restrcted as it would be in an enclosed duct.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by
Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights
reserved.
http://home.earthlink.net/~rotaryeng/           
http://www.linux.org