Subject: E-shaft Bolt 19mm
From: ACRE NL
Date: 8/8/2002, 9:46 AM


Tom Webber wrote:

Help,  I'm in the process of pulling my engine apart and can't seem to
get the from E-Shaft 19mm bolt loose.  I've used a 18" ½"drive breaker
bar and bounced on it but it just won't break loose.  Any Idea's, Heat /
Hammer.  Thanks for any help.  T.W.

You need a really big breaker bar Tom. 3 or 4 feet long.
--
Paul Lamar

Bulent Aliev wrote:

Heating it with propane torch also will help
Bulent

Thanks everyone,  I got it loose last night.  I learned in the process $$ don't hit the socket with a hammer while applying torque. I finally got the bolt loose with heat (torch) and cooling.  Then the 1/2" breaker bar and a short cheater did the trick.  Upon removal of the front cover and oil pump gear assembly I found the blow with the hammer drove the thrust washer in to the bearing with enough force to mark the washer.  I was going to replace anyway but still.  Live and learn.

Tom Webber


The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org