--> > NTSB Identification: LAX02LA220
Accident occurred Friday, July 05, 2002 at
Pahrump, NV
Aircraft:Bushby Aircraft Mustang M-11,
registration: N30430
Injuries: 2 Uninjured.
This is preliminary information, subject to change, and may contain
errors. Any errors in this
report will be corrected when the final report
has been completed.
On July 5, 2002, about 1200 hours Pacific daylight time, an experimental
Lazaro/Bushby Mustang M-11,
N30430, experienced a propeller
blade failure during cruise flight, resulting in a forced landing on a dry
lake bed near Pahrump,
Nevada. The personal flight was operated
under 14 CFR Part 91. Neither the private pilot nor his passenger were
injured. The airplane
sustained substantial damage. Visual
meteorological conditions prevailed, and no flight plan was filed. The
flight originated at Pahrump
at an undetermined time.
The pilot contacted a Federal Aviation Administration (FAA) inspector at
Las Vegas, Nevada, and
reported that he had experienced a
propeller blade failure while en route to Pahrump. He stated that post
accident examination of the
airplane revealed that 21 inches of a
propeller blade had separated. The propeller is an aluminum two bladed
McCauley fixed pitch.
According to the pilot, the resultant imbalance resulted in substantial
damage to the airframe,
leaving the engine hanging by one 3/8-inch
bolt.
I have been trying to decide where to hook up a safety cable on my tube and
fabric Sportsman. Right now
I am thinking that a tab on each upper 3/8" bolt that holds the mount to the
airframe is the stongest place to
attach. This guy said there was only one 3/8 bolt left. Would this be at the
rubber isolation mount?
Is the weak point out at the rubber mounts or where the mount bolts to the
airframe?
Also if I use 2 cables is 1/8" heavy enough?
Lonnie
Got a picture of the fuselage frame Lonnie?
Here is an old picture of your motor mount.
I would drill a couple of small holes in the firewall and run a 1/4 inch cable
in one hole, around one or more major steel tubes and back out the other hole and
around
the engine some place. Safety wire the cable where it comes out of
the firewall and apply a little red RTV to seal the holes.
Here is a scan of the Sportsman fuse.
Run the cable behind all four of these tubes just behind the firewall.
BTW You must be getting close to first flight. How is it coming?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org