There is a structural problem with these venetian blind cowl flaps
and a wide but short fore and aft horizontal rad
under the engine. The aero loads can cause bending and perhaps flutter.
You can make a fairly thick streamline shape and cover it with carbon
fiber and hinge it on the ends or you can use piano hinges and sheet
metal. The piano hinges can be fastened to the rad itself to support
the flaps along their leading edges as in this rendering of just
one segment.
This can be done by several thin strips of metal that slip in between
the fins. Not shown in this rendering. Also small holes could
be drilled in the piano hinges to safety wire them to the
back side of the rad.
Paul Lamar
Careful thought is advised before anything is inserted
between the fins of a heat exchanger. A friend safety wired
a 'universal fit' electric cooling fan to the back of his
truck radiator & it cost him a motor when the mounting wires
sawed through the core tubes.
Charlie England
Good point Charlie. Delete the safety wire :-) I knew that!
I got a little lazy there. I was going to suggest putting RTV
or a drop of epoxy around the safety wire to keep it from chaffing.
I'll bet the fan came with plastic ties and he decided to use safety wire.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org