Subject: Anothe Rotary Glider Event - Infamous Resistor in Lead Ign Unit
From: ACRE NL
Date: 8/15/2002, 6:03 PM


Ed Anderson wrote:

The problem is the 0.3 ohm resistor in the base of the leading ignition
module  is apparently inadequate to handle the continous high rpm ignition
load hour after hour.  It appears to overheat and open up.  The fix is to
install a resistor with a higher wattage rating.  I use a 10Watt resistor
situated on the outside of the case( not enough room in the case for the
larger wattaged size) and Tracy recommends a 25watt capacity.  I might
suggest wiring two ten watt sizes in parallel for the additional redundancy.

If you wire two resistors in parallel, don't forget to double each resistor's
value.  In this case, use two 0.6 ohm 10 watt resistors in parallel to make one
0.3 ohm 20 watt load.

Russell Kent

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org