Subject: Anothe Rotary Glider Event - Infamous Resistor in Lead Ign Unit
From: ACRE NL
Date: 8/16/2002, 5:50 AM


If you wire two resistors in parallel, don't forget to double each resistor's
value.  In this case, use two 0.6 ohm 10 watt resistors in parallel to make one
0.3 ohm 20 watt load.

Russell Kent

I think you need to halve the resistances for a parallel circuit -- two .15 ohm resistors in
parallel will give an equivalent 0.3 ohm resistance. The wattage does double as you have said
two 10 watt resistors of equal resistance in parallel will handle 20 watts total.

Jonathan Lauter
Rotary Power Marine Corporation
516-656-5685
www.rotarypowermarine.com


Double the resistance. Russell is right as usual.

Paul Lamar


Of course, you are both right. BIG brain fade on my part! Very Sorry!

Jonathan Lauter
Rotary Power Marine Corporation
516-656-5685
www.rotarypowermarine.com

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org