As I was looking at this information on Square Tube Elbows for intake and
exhaust manifolds, I noticed that they were available in Aluminum as well
as
Stainless Steel.
Would Al square tube elbows simplify fabrication and installation of
tuned
intake manifolds?
Yvon Counoyer.
I think it would make it even more difficult. Not only is the area of the
ports different than the area of standard tubing sizes but there is an
oval
on one end and something else on the other end as well. See the 3D below.
Also, square tubes have more skin friction drag and that is one reason
they are good for quieting exhaust gas pulses. They are not as good for
intakes
where you need low skin friction drag and high efficiency.
Paul, that's exactly how I shaped my intake tubes just that mine are 180
degree bends from Burns. My problem was the middle two, but I decided to
have one tube to supply both ports, since they open one at the time and the
manifold is pressurized by the turbo.
Bulent
Yes but how did you change the area of the tube to match the area of
the port? Or did you? :-)
Yes, I did very carefully and they match the ports very well. I believe Ed
Anderson did the same thing. All I used is a big vise, ball point hammer,
file and wood dowels.
You will see on the photo my stock manifold, my pattern for the int.
manifold plate and the two outside tubes.
Bulent
OK I see. You went straight up and over and you started with a Cosmo
engine. That is easy but it won't clear a stock turbo, low cowl and maybe
not a TO4 mounted high enough to drain back and still fit in a stock
cowling. In your case you have plenty of room being behind the
cabin of a Cozy. Did not we discuss this before at one time? :-)
What sizes of tubing are you using Bulent?
Paul Lamar
Paul, I don't have the tube sizes on hand since the parts are at the
airport.
Bulent
OK
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org