Bob Darrah wrote:

It looks like that oval the engine mounts to is 16 by 26.  It's about 70
inches to the prop flange.  The engine cowling at its largest point is 24 by
36 inches (IIRC) and the thrust line is about 1 inch below the top of the
oval.

I am using the original dynafocal mount, but a much neater package could be
made if you started from scratch.

Hope this helps.

Bob Darrah

Thanks Bob I will see what I can come up with.
I am thinking maybe cutting off the dynafocal part and start from
there. The back part looks fine. How wide and high  is  it at the 
dynafocal part?

How is your rad test coming?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org