Subject: Gear support (Non rotary)
From: ACRE NL
Date: 8/21/2002, 8:09 PM


Peter Cowan wrote:

Can anyone give me suggestions on this spring gear attach problem?
What I've got is a Cessna 185 spring gear on a steel tube airframe. The
"U" bolt is a 3/4 x 1"
aluminum bar with two 3/8 bolts. Here is a picture looking out from the
center of the fuselage to
the right gear leg. The frame would be at the top; the gear in the
notch:


The last couple of flights I noticed oscillation at the wheel just after
first touch down
indicating the gear was loose. Lifting the plane off the ground allowed
the gear to really flop
around. You can see that the bar is bent on the left (to front of the
plane). The odd shaped
blocks were cut to position the gear with the correct toe in/out and
clear structural tube. Unlike
Cessna installations these retaining bolts are a couple of inches
further away from the gear on
each side.
I can replace this assembly with one made up out of steel but would like
to build in some "give".
Is there any rubber type material that could with stand the loads yet
provide some cushioning in
this area? One thought was to wrap the gear in multiple layers of a
glass cloth and silicon
laminate. Any other suggestions are appreciated.
Peter

Fiberglass reinforced rubber belt material would work fine. No way around
the bending
problem other than steel unless that aluminum is a soft alloy. Try making
it out of
7075 T6. Also make it 1" by 1" instead of 3/4 by 1. That way it will be
only
25% heavier instead of three times heavier.

Paul Lamar

Thanks Paul.
What is the typical use for that belt material to help me locate a source.
I did come across a chunk of 1 x 1 square stainless that I'll try although
wall thickness is only about .040.
Peter


Industrial supply flat belts for power transmission. Farmers use it.

Was that tubing? I thought it was 3/4 by 1 bar stock.
.040 wall stainless is a bit marginal. 

If tubing it could have been mild steel tubing.
Plain 4130 or heat treated 4130 tubing would be a lot better. 

The bending strength formula is proportional to the height of the beam squared
so .75 x .75 is .56 while one x one is one or 178% of the original strength.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org