Peter Cowan wrote:
Can anyone give me suggestions on this spring gear attach problem?
What I've got is a Cessna 185 spring gear on a steel tube airframe. The
"U" bolt is a 3/4 x 1"
aluminum bar with two 3/8 bolts. Here is a picture looking out from the
center of the fuselage to
the right gear leg. The frame would be at the top; the gear in the
notch:
The last couple of flights I noticed oscillation at the wheel just after
first touch down
indicating the gear was loose. Lifting the plane off the ground allowed
the gear to really flop
around. You can see that the bar is bent on the left (to front of the
plane). The odd shaped
blocks were cut to position the gear with the correct toe in/out and
clear structural tube. Unlike
Cessna installations these retaining bolts are a couple of inches
further away from the gear on
each side.
I can replace this assembly with one made up out of steel but would like
to build in some "give".
Is there any rubber type material that could with stand the loads yet
provide some cushioning in
this area? One thought was to wrap the gear in multiple layers of a
glass cloth and silicon
laminate. Any other suggestions are appreciated.
Peter
Fiberglass reinforced rubber belt material would work fine. No way around
the bending
problem other than steel unless that aluminum is a soft alloy. Try making
it out of
7075 T6. Also make it 1" by 1" instead of 3/4 by 1. That way it will be
only
25% heavier instead of three times heavier.
Paul Lamar
On the KIS family of airplanes we use a one pc aluminum spring gear and
the mounting scheme is similar
to the attached sketch. Rubber or other elastomer is critical in attaching
spring gear. The mounting
point is going to rotate, and unless you provide elstic deflection,
something is going to yeild.
we use a closely machined aluminum U clamp - the deflection will close on
the gear leg
clamping it securely and limiting the bending of the clamp. Die rubber about
1/4 in thick is used on
both sides (particularly with composite to prevent point loads from
destroyong the matrix)
and som builders have felt that a harder rubber is called for. - Vance
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org