I still need the dimensions of the turbo exhaust manifold.
Also how far back of the spar is the trailing edge of the wing?
Do you have a top view of the airplane?
This is not cast in concrete as there are some other motor
mount options that will work. One trick is to freeze larger Barry 22003
rubber mounts and drill some holes in them to make them softer. Then drill the
5/8 inch mounting bolts to make them lighter :-) Then move the mounts
inboard to give a more pointed cowl.
BTW I can give you loft lines so you can carve the cowl when
you see something you like.
Paul Lamar
On the subject of "making your own"
It came to me that if I were making my own exhaust manifold I could then move the turbo far enough
away to go ahead and use aluminum weld el's to make a intake manifold. The entrance to the intake
ports would not have to be as sharp and radical either. This will call for a lot of 3d modelling
as pushing the turbo out also impinges on motor ounts.
...Chrissi
Cozy Mk-IV 13B-turbo
www.CozyGirrrl.com
Chrissi@BlueMountainAvionics.com
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org