Jerry Hey wrote:

Paul,   very sorry to have to ask you to send the oil pan drawings
to me again.  I have misplaced them on this computer.  80gigs of
storage,  they are in there someplace.   Did you modify the oil
pick-up?  Lastly,  I just removed the oil pan plate (Tracy's design)
and I could not remove it without unbolting the oil pickup.  No
problem as the pan was removable.  How do you do his when the pan is
welded to the plate?     Jerry

Use the big hole. Yes you might have to cut and weld the oil pick up tube.
That was before 3D so I screwed up and the oil screen
hits the bottom. You might want to make yours a half 
inch deeper.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org