Subject: Cozy cowl vs SQ2000 vs make your own
From: ACRE NL
Date: 8/27/2002, 12:29 AM


Joseph Berki wrote:

Paul,
         One thing that I have observed in this project is that on the
EZ
designs, the shape of the cowl  is extremely important.  A builder and
prop
designer, Bruce Tift, had done an extremely clean version of the Long
EZ
and decided to use the IO-360 engine which required bumps and blisters
in
the cowl.  The plane flew slower than a standard Long.  A conversion
for
most Longs is to replace the 0 235 with a 0-320.  My friend did this
to his
Long.  In the process he eliminated the NACA inlet and went with ram
air
for the carb, put the scoops on top for the engine cooling and fit the
cowl
very tight with a small boat tail.  He went from 160kts to 200kts for
top
speed.  Some was the engine but I think a lot of the increase was  do
to
the  cowl.
Joe Berki
Limo EZ

Yes I agree. The fast EZ airplanes at Jack Pot all pay strict attention
to making the cowl as small as possible as does Klaus. Charlie Airesman
got remarkable results by using a long prop shaft with an aux
prop shaft bearing and a long tapering cowl.

Paul Lamar

Since y'all are talking about this, I will ask some questions I have
been stewing over.  I am building a highly modified version of the Cozy
MkIV.  6" wider, full retracts, Rotary of course.  My question assumes a
couple of things:
1. Boat Tails are better

2. Three blade props are smoother on pusher's (airflow coming off the
wing and both blades hitting it at the same time _supposedly_), but this
can be offset by locating the prop farther aft.

I am also curious what the group thinks about interference drag as
referenced by Mike Arnold of AR-5 fame.  Looks to me like the "Stock"
Cozy/AeroCanard/SQ2000 cowls ignore this theory.  Mike Arnold thinks
this is a major reason his AR-5 is so slick.  I would like to see if his
technique for reducing/eliminating interference drag can be applied to
my cowling.  This would require the prop be moved some inches aft.  Need
to get a copy of Rhino for myself and try a few things.

I am trying to fit a radiator below the engine, with a P-51 style duct
and an adjustable boat tail style exit for the water radiator.  I would
use smaller P-51 style armpit ducts for the Oil cooler and intake.

So, my question is what kinds of problems am I likely to run into with a
configuration that puts the two blade LAEV prop far enough behind the
firewall to allow the wider fuselage to have a gentle if not pressure
recovery shape that will reduce interference drag?  Can I make my own
PSRU, and just add more length to it?

This also leads into another question somewhat specific to pushers, and
that is the most efficient way to re-introduce the cooling air into the
air stream without causing more drag.

tc

After doing a 3D I am not sure boat tails are better. The Cozy is too
wide I think for a boat tail to be effective.

Yes you can make your own PSRU :-) Moving the prop back has its limitations.
That is prop strike on rotation. You could perhaps lengthen the gear.

Last question; I am still thinking about it :-)

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org