I have come up with a scheme that might work. It uses the turbo
to suck the boundary layer away from a recessed parallel sided
air scoop under the fuselage. It is NOT a NACA duct!!!!
It is a conventional scoop where the air is deflected upwards towards
the bottom of the perforated fuse skin by mechanical suction from
the turbo.
You will have to make a test box and mount it on a van as I am
not sure if it will work or not work. Consequently you will also
need a fairly large test blower to simulate the turbo suction.
The turbo, at full power, can suck about 25 pounds of air per minute.
At sea level air density is about .0015 pounds per
cubic foot so the test blower would have to move about 17,000
cubic feet per minute or 280 cubic feet per second to simulate
a turbo if my calc's are right.
Paul Lamar
Paul,
I need some help understanding the turbo charts please. Can you explain at
what rpm the turbo-selection-criteria3 chart bases its numbers? With a
2.17:1 ratio, we're running considerably below full power. If the chart is
based on lbs/min at redline, won't the chart's numbers be too high for an
engine that won't see more than 6000 rpm? It seems that something less
than what the chart shows would be more suitable for our applications but
the chart doesn't indicate the rpm that the numbers are based. Should we
extrapolate to get to a ballpark number or go by the numbers shown? Am I
the only one that doesn't see the light?
Mark
All good questions. It is right out of the Turbonetics catalog.
My guess is these are racing RPMs. 6k to 7K. On the other hand
the volumetric efficiency of the rotary runs higher than that
of most piston engines so it uses more air at a give RPM.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org