Jerry Hey wrote:

Paul,  would you please check the  photo to make sure I have it
right.   I will ask Danny to write cnc instructions so that we can
cut these on demand.    Why did you eliminate the dip stick hole?
Looks like it would still work.     Jerry

Yes it looks about right. Good point on the dip stick
hole. Put it in. I left it out because I was going
to do something else.

Unlike the motor mounts no guarantees on this one.
Foamed oil drain back is a mysterious thing :-)
If it is made from 3/16 one can always get out their hole
saw and put a few more holes in the top plate of the oil pan.

Paul Lamar

Paul, I wouldn't omit that third engine mount hole you're x-ed out. Seems that
would be a potential leak area. I have a bolt in that hole just for that. I
assume this is a baffle for the standard oil pan?

Finn

Those are Jerry's X's not mine. It won't leak because he is not using
the stock pan. This is a custom pan that does not use
that motor mount hole. For that matter it does use the outer two 
motor mount holes either.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org