Don Dunbar wrote:

Hi there Paul,
There has been little progress over the last few months as I have been very busy at work.
The PRSU has reached the final stage with some small modifications to take place.
I have attached some photos for you and the group.
All up wieght including the bell housing, flywheel and drive flexy coupling is 21Kg or 46lbs.

I sent an earlier drawing that did not show the critical thrust bearing.
Here is a later drawing showing the necessary sun gear thrust bearing.

Don, when I get some time I will do a 3D of your Mustang II engine compartment.
Robin is already bugging me to go back to Australia. We may leave any minute :-)

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org