Subject: Mustang 2 DWG 3D
From: ACRE NL
Date: 8/30/2002, 11:44 PM

Don Dunbar wrote:

Hi again Paul,
I will be using the standard turbo and manifold.
Regards Don

OK just got a 3D done with the tuned muffler but no problem
putting in the turbo.

The space under the engine is kind of tight in the Mustang II. We 
discovered that putting the motor mounts in the stock 2nd gen position 
like shown here uses up a valuable couple of inches under the engine 
where you might want to put your rad. This 3D confirms that.
Makes the cowl kind of deep. I'll try to think of something else.
If you have some other ideas let me know.

I have not modeled your PSRU yet but will do that soon and replace
Tracy's as shown.
 

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org