Jerry Hey wrote:

It would sure be nice to have a water pump neck with  a more useful
angle.     Jerry

Which one? Top neck or bottom neck?

I am getting pretty good at this computer pattern making.
This may look simple but the learning curve on this was steep
for me. It is the first half of one of the four core boxes
required for the new cast intake manifold. It is in the
stereo lithography machine as we speak. It will take 4.5 hours
to make while I sleep. I will have it in hand next week to take
pictures. I am pretty excited. This partially replaces a $3500
dollar charge for pattern making.

Now as to a new water pump housing casting how bad do you want it
and where should the inlet and out let be? :-)

Paul Lamar

You could sell a batch of those. Will it fit a 20B? How about a series
of these?
[Marc Wiese]

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org