Don Dunbar wrote:
Hi again Paul,
I will be using the standard turbo and manifold.
Regards Don
OK just got a 3D done with the tuned muffler but no problem
putting in the turbo.
The space under the engine is kind of tight in the Mustang II. We
discovered that putting the motor mounts in the stock 2nd gen position
like shown here uses up a valuable couple of inches under the engine
where you might want to put your rad. This 3D confirms that.
Makes the cowl kind of deep. I'll try to think of something else.
If you have some other ideas let me know.
I have not modeled your PSRU yet but will do that soon and replace
Tracy's as shown.
Paul Lamar
Don & Jim,
I moved the rad up to the cool side as the cowling was ugly with the rad
underneath. You will have to have louvers or venetian blind type
cowl flaps over there as the back side of the rad MUST be totally
unobstructed. The rad is the same size. About 17 by 20 by 2 inches.
This also left little room for the stock turbo location
so I moved that back. If you go this route you will have to fab a
turbo exhaust manifold. RB Wganer has .140 thick 304 SS bends. Using
those it should be a piece of cake.
You could pick up a little clearance with the motor mount tubes
around the turbo by using a beam under the front of the engine like
Bill Schertz did and move the motor mounts outboard 3 or 4 inches
on each side.
What kind of air intake would you like to use? Mostly a cosmetic issue.
Let me know if you want to try some other arrangement.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org