Subject: Updated cooling articel on web site.
From: ACRE NL
Date: 9/1/2002, 10:18 PM

I have updated the cooling article on the web site with what we have
learned from the radiator ducting tests on top of the Dodge Caravan.
Rather than bore you with the whole article here is the main paragraphs
that are different.


"The Hard Part. Getting The Air To Go Through The Heat Exchanger.

Here is where most builders have difficulty. It is not easy to design a low 
aerodynamic drag aircraft liquid cooling system. The cooling drag can be as 
much as 30% of the overall drag on the airplane. The scoops and ducts must  
be designed properly. The job of the duct is to slow the air velocity and to
raise the pressure to the point that it optimise's radiator performance.
Many lessons were learned in world War I & II on this subject. Some
important improvements did not have time to be applied during the war so   
some of the best lessons can not be learned by studying WW II aircraft. The
P51 seems to be the ultimate liquid cooled aircraft of WW II yet its duct 
system has been improved upon by some work published after the war.  There
is an out of print book written by Kuchemann and Weber published in 1953
called The Aerodynamics of Propulsion wherein much of this has been
presented. Used copies are still available on the Internet.
Prior to this work most duct designers thought it necessary to design the   
duct so there was a gradual transition from scoop opening to heat exchanger.
See figure x. This is not the case and a more bell shaped transition is  
called for such as figure y. The coordinates of such as duct are given in
table a.

The other half or more of the equation is getting the air out on the back
side of the heat exchanger. According to our test of off the shelf car
radiators using a duct mounted on top of a Dodge Caravan (see picture on the 
web site) and a water manometer it is very important to have a clear space  
behind the heat exchanger. The air flow coming out of the rad can be as high
as 40% of the forward speed of the airplane. If there is an object within
ten inches behind the typical radiator this air velocity will convert to
static pressure on the face of the object. This in turn will impede the air
flow through the rad in that area. It is best to mount the heat exchanger
on the inside surface of the cowl and have a totally unobstructed back side."


Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org