OK Jerry here is the exhaust system.
This uses four inch radius tubing bends with two inch tubing.
Five inch radius will stick out further and not give as much
motor mount tube clearance. I rotated the double 45 degree
S bend at 45 degrees and not ninety. Keeping the S bend plane
perpendicular to the MM tube gives the most clearance.
This is as tight as it can get using two 45 degree bends
and a 180 degree bend. You could cheat a bit and make some
of the joints less than tangential.
It pokes through the cowl slightly. In any event you would
need a metal cowl plate in this area because of the high heat.
I suggest getting your money back or sell those bends
and get low cost SS three inch center line radius pipe bends
from RB Wagner. RB Wagner uses the inside radius so what they
call two inch radius is really three inch center line radius.
BTW 1-1/2 inch pipe is 1.9 inch OD so you gain a bit there.
Or forget going around the outside of the tubes, making a wider
motor plate and widen the motor mount tubes to run the exhaust inside
the motor mount tubes. [Incoming! Running for cover :-)]
Or weld up some bent square tubes out of SS flat sheet.
BTW Your rad will require 4.5 to
5 inches clearance from the bottom of the motor plate to
the rad edge to get a large enough area rectangular duct
through there. This tends to limit the up angle at which you
can run the rad and the up slope to the bottom of the cowl.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org