Subject: Heater water outlet
From: ACRE NL
Date: 9/5/2002, 8:53 PM


Didn't George Graham already do that?  His rad is fed by NACA duct.  No
cooling problems after he unblocked the heater hose inlet. EZs fly at a
1
or 2 degree nose up attitude.
Joe Berki

Joe, "after he unblocked heater hose inlet"? ..whats that all about?
...Chrissi

Cozy Mk-IV 13B-turbo
 www.CozyGirrrl.com
Chrissi@BlueMountainAvionics.co

Chrissi,
I believe I remember reading on George's site that he experienced an
improvement in coolong after reconnecting the aft heater outlet which he had
originally blocked off.
Dean

     To all concerned,
        This might be a thread to concern us all. It is well known that the
 rear rotor housing (front in tractor A/C,rear in pusher) runs at a higher temp
 than front housing because coolent cools front first then flows to rear housing.
        Opening the heater outlet on the rear housing and sending coolent back
 to pump inlet will increase flow through rear housing. Most 13B's fail at the
 rear rotor probably because it runs at higher temp IMHO.

       Kelly Troyer


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org