Opening the heater outlet on the rear housing and sending
coolent back
to pump inlet will increase flow through rear housing. Most 13B's
fail
at the
rear rotor probably because it runs at higher temp IMHO.
It would be a shame if you did not use that hot water!
This is a good place to reuse that heater core from your junk for cold
weather flying (or high alt turbo flying!). Makes CO2 a thing of the
past. Just make sure the core works all the time by ducting the air
overboard instead of to the cabin when not needed. A flapper door can do
that.
[Marc Wiese]
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org