Didn't George Graham already do that? His rad is fed by NACA
duct. No
cooling problems after he unblocked the heater hose inlet. EZs
fly at a
1
or 2 degree nose up attitude.
Joe Berki
Joe, "after he unblocked heater hose inlet"? ..whats that all
about?
...Chrissi
Chrissi,
I believe I remember reading on George's site that he experienced an
improvement in coolong after reconnecting the aft heater outlet
which he had
originally blocked off.
Dean
To all concerned,
This might be a thread to concern us all. It is well known that
the
rear rotor housing (front in tractor A/C,rear in pusher) runs at a
higher temp
than front housing because coolent cools front first then flows to rear
housing.
Opening the heater outlet on the rear housing and sending
coolent back
to pump inlet will increase flow through rear housing. Most 13B's fail
at the
rear rotor probably because it runs at higher temp IMHO.
Kelly Troyer
Just another data point FWIW
I wondered about this too after George reported a big cooling improvement.
I re-configured my cooling system to use the heater port and carefully
monitored coolant temps but could detect no improvement. I changed it back
to the old configuration because it had shorter & fewer hoses.
I don't have an explanation for the different results. One possible clue
was that George has a relatively complex system using (as I recall) 2 oil
coolers and 3 coolant rads. There could have been some factors at work that
we are not aware of.
Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com
Probably had an air pocket in the cooling system and in a pusher the block heater
outlet is the highest point when the canard nose is sitting on the ground.
It is essential that the highest point in the cooling system be vented
when filling with coolant.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org