Tom Kendall wrote:
Here's some photos of the completed pattern for the 20B intake manifold.
Some details:
The boxy looking items are core boxes that are used to make the sand
cores. I've split them open
along their parting lines and laid them out so you can clearly see how
the 6 ports (2 per rotor)
will each be supplied by a single, oversized runner.
The parts that are painted black on the main pattern represent where the
cores will be and will
*not* exist on the finished piece. However, you can think of the three
big black cylinders as
being the runners. That is where they will stub in.
I've located some aluminum brazing rod that will make it very easy to
connect assembled weld bends
(or pre-bent pipe) into sockets bored into the manifold casting. This
will eliminate the risk of
ruining a casting and/or runner due to the differences in thickness,
while keeping the advantages
of a good tight metal-metal joint (I just don't trust Devcon or similar
for my pressurized
air/fuel mixture!).
Note that the runners will be routed over the centerlines of each rotor
housing, and that all bolt
heads will be readily accessible without any tricks. Also, by keeping
all faces, machining, and
boring operations to easy right angles, the boring and drilling can be
done on a home drill
press! All I need the machine shop to do is clean up the mounting face.
So... what shall I do with this gang? I'll probably get one cast now
and try it out (Barney's?).
After that, anybody else interested?
Tom Kendall
Any estimates on the weight? If the weight of the casting is reasonable,
I'd be very interested.
Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org