Tom Kendall wrote:
Here's some photos of the completed pattern for the 20B intake manifold.
Some details:
The boxy looking items are core boxes that are used to make the sand cores.
I've split them open
along their parting lines and laid them out so you can clearly see how the 6
ports (2 per rotor)
will each be supplied by a single, oversized runner.
The parts that are painted black on the main pattern represent where the
cores will be and will
*not* exist on the finished piece. However, you can think of the three big
black cylinders as
being the runners. That is where they will stub in.
I've located some aluminum brazing rod that will make it very easy to connect
assembled weld bends
(or pre-bent pipe) into sockets bored into the manifold casting. This will
eliminate the risk of
ruining a casting and/or runner due to the differences in thickness, while
keeping the advantages
of a good tight metal-metal joint (I just don't trust Devcon or similar for
my pressurized
air/fuel mixture!).
Note that the runners will be routed over the centerlines of each rotor
housing, and that all bolt
heads will be readily accessible without any tricks. Also, by keeping all
faces, machining, and
boring operations to easy right angles, the boring and drilling can be done
on a home drill
press! All I need the machine shop to do is clean up the mounting face.
So... what shall I do with this gang? I'll probably get one cast now and try
it out (Barney's?).
After that, anybody else interested?
Tom Kendall
My Cosmo 13B can use one if you can shorten it for two rotors. The port
sizes are the same.
Bulent
Tom,
And if you can shorten it to one rotor (front housing, rotor housing,
rear housing) some of the 6.5B guys might be interested.
Fred O.
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org