Note that the runners will be routed over the centerlines of each
rotor housing, and that all
bolt
heads will be readily accessible without any tricks. Also, by
keeping all faces, machining,
and
boring operations to easy right angles, the boring and drilling can
be done on a home drill
press! All I need the machine shop to do is clean up the mounting
face.
So... what shall I do with this gang? I'll probably get one cast
now and try it out
(Barney's?).
After that, anybody else interested?
Tom Kendall
I'm definitely interested. How much and where to mail the check?
Chris
microcosman.com
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org