<Snippage>
Any estimates on the weight? If the weight of the casting is
reasonable,
I'd be very interested.
Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com
I'll venture a guess: The prototype (and very chunky) manifold for the 13B
was 5 lbs. This one should be about the same. Even though it's longer,
I've got less metal in the "humps". 7.5 lbs at the outside (5 lbs x 1.5).
"Adders" will be the weight of the runners themselves (I'm planning on using
2" diameter aluminum pipe), and any plenum, carbs, throttle bodies, etc.
If you have the room Tracy, a standard radius 90 degree bend can be used
right off of the manifold that will clear the stock fuel rail. If you
don't, then plug the stock injectors holes in the small ports, and use a
shorter radius (non-standard) bend from the handrail folks... that should
keep your under-cowl height below whatever you end up with for a water pump.
The shorter radius bends will need to be seal-welded however: they have an
unwelded longitudinal seam on the inside of the bend.
I'm ordering up parts for the engine to put it back together. At some point
this winter I'll be jigging up tubing & pipe and trying to make the runners,
injector bosses, and an inlet plenum. Will keep you posted.
TCK
Tom Kendall
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org