Subject: 20B Manifold -- ready to cast #1
From: ACRE NL
Date: 9/8/2002, 1:32 PM


Tom Kendall wrote:

Here's some photos of the completed pattern for the 20B intake
manifold.

Some details:

The boxy looking items are core boxes that are used to make the
sand
cores.  I've split them open
along their parting lines and laid them out so you can clearly
see
how
the 6 ports (2 per rotor)
will each be supplied by a single, oversized runner.

The parts that are painted black on the main pattern represent
where
the
cores will be and will
*not* exist on the finished piece.  However, you can think of
the
three
big black cylinders as
being the runners.  That is where they will stub in.

I've located some aluminum brazing rod that will make it very
easy
to
connect assembled weld bends
(or pre-bent pipe) into sockets bored into the manifold casting.
This
will eliminate the risk of
ruining a casting and/or runner due to the differences in
thickness,
while keeping the advantages
of a good tight metal-metal joint (I just don't trust Devcon or
similar
for my pressurized
air/fuel mixture!).

Note that the runners will be routed over the centerlines of
each
rotor
housing, and that all bolt
heads will be readily accessible without any tricks.  Also, by
keeping
all faces, machining, and
boring operations to easy right angles, the boring and drilling
can
be
done on a home drill
press!  All I need the machine shop to do is clean up the
mounting
face.

So... what shall I do with this gang?  I'll probably get one
cast
now
and try it out (Barney's?).
After that, anybody else interested?

Tom Kendall


Any estimates on the weight?  If the weight of the casting is
reasonable,
I'd be very interested.

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com

Marc Wiese wrote:

Maybe tracy could handle them? I would be interested.........

Marc Wiese

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org