Subject: 20B Manifold -- better radius?
From: ACRE NL
Date: 9/10/2002, 7:32 PM

Tom Kendall wrote:

<snip>
If it is possible to remove some material it might flow better with a
bigger radius on that inside curve as I have drawn on that attached JPG.
Also could we cut one in two and have one for a 13B and one for a 6.5B?
We would have to weld on an extension to replace the missing flange
edge.

Chuck Dunlap


At first glance, this looks like a good suggestion Chuck.  But there's a
couple of things that kept me from going any further in easing this
transition:

The radii on the cores is made to match the pattern to keep a nearly
constant 3/16" wall thickness on the manifold.  Much thinner and the metal
won't consistently fill the gap between the cores and the impression made by
the main pattern.  Much thicker and the whole thing gets a bit clunky.
Also, changes in wall thickness can create stress and shrinkage problems as
the whole thing cools.  So I tried to avoid those wherever possible.

That being said, in this one area, I intentionally kept things a little
thicker because this is where the machining for the runner pipes will take
place.  I wanted to make sure there was a "bottom" for the runner socket
once it gets bored out.  If I contoured as large a radius as you suggest,
the socket bore would break out into the main cavity well before it got to
the full 3/8" depth I'm shooting for.

Unfortunately, I couldn't extend the "neck" any further and still have hope
of being able to fit the bends under anybody's cowl.  Every inch from the
socket face on up is to be for pipe bend, and it'll be a tight squeeze at
that.

But if all goes well with the prototype, some hand "porting" of the finished
casting may be in order, and perhaps some tweaking of the pattern if that
works out.

Thanks!

Tom

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org