Tracy Crook wrote:
Jerry Hey wrote:
Hi Tracy, Can I use your controller with Peripheral Ports? Jerry
Sorry for the delay, I saw this last week and never got around to answering.
The answer depends on exactly how the engine is built. If it is done like
Powersports' engine with the throttle valves in the rotor housings, it may
not be possible. The reason is that the EC2 is a Speed - Density type
controller. This means it needs to know manifold pressure as a primary
input. The manifold pressure in their setup is always at ambient since the
throttle valves are down stream of the manifold.
One possibility is to tap into the intake runner on the rotor side of the
throttle (if possible).
I was working with Everett Hatch on a version of the EC2 for use with the
Powersport engine when he was killed. It was going to work off the servo
signal from the venturi used with the Airflow Performance system that they
used to use.
What sort of throttle system were you planning to use on your PP engine
Jerry?
Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com
I think you can drill a hole and get the pressure down stream
of the throttle plates even if they are mounted in the rotor housing.
What is the response time of those pressure sensors you are using
Tracy? Do you have any problems with intake manifold pulsation's?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.