Subject: air seperator tanks......late model design
From: ACRE NL
Date: 9/13/2002, 11:32 AM

Marc Wiese wrote:


I think the difference is that automobiles universally have radiators
with one of the tanks above the engine.  If the rad is below the
engine you will need a swirl pot.    Race cars with low radiators
have swirl pots.  Jerry
All the 13B rew tt FDs (93+) have the chamber pots (separator for air
and water). Line connects to overflow tank, the coolant is pushed
out/drawn back in thru this device) as shown in this picture. They are
made of plastic, the seams are know to separate at odd times, so there
are many metal versions available. However the pump cap is just about at
the SAME height, so go figure. The radiator position is very low and
angled, and of course blocked by the ac condenser as well, and it has 2
electric fans that come on whenever the ac is on, or when water
temp>226F. Very poor airflow characteristics. In racing the ducting to
the intercooler is known to reverse airflow and suck HEATed air. The
tank is required to be replaced with a metal tank on the track, since
spewed antifreeze on the road is so slippery as to be dangerous. The
97+non usa models revised the intake ducting and enlarged the bumper
openings, somewhat to improve the flow.
I haven't seen the design of the new ducting, but I did hear Mazda went
to electronic boost controls in 98 or so and deleted all the vac
operated solenoids.....anyone see that arrangement (Australia?)?
 I hope Mazda gets the rx8 flows right.
Marc Wiese


In general folks please crop and reduce the pixel count of
submitted images to less than about 100K. Less than 50K if you send more
than one and would like to see more than one with your published message.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.