Subject: Peripheral ports & EC2 use.
From: ACRE NL
Date: 9/14/2002, 7:38 PM


Tracy Crook wrote:

 Jerry Hey wrote:
 Hi Tracy,   Can I use your controller with Peripheral Ports?     Jerry

 Sorry for the delay, I saw this last week and never got around to
answering.

 The answer depends on exactly how the engine is built.  If it is done like
 Powersports' engine with the throttle valves in the rotor housings, it may
 not be possible.  The reason is that the EC2 is a Speed - Density type
 controller.   This means it needs to know manifold pressure as a primary
 input.  The manifold pressure in their setup is always at ambient since the
 throttle valves are down stream of the manifold.

 One possibility is to tap into the intake runner on the rotor side of the
 throttle (if possible).

 I was working with Everett Hatch on a version of the EC2 for use with the
 Powersport engine when he was killed.  It was going to work off the servo
 signal from the venturi used with the Airflow Performance system that they
 used to use.

 What sort of throttle system were you planning to use on your PP engine
 Jerry?

 Tracy Crook
 tcrook@rotaryaviation.com
 www.rotaryaviation.com


I think you can drill a hole and get the pressure down stream
of the throttle plates even if they are mounted in the rotor housing.
What is the response time of those pressure sensors you are using
Tracy? Do you have any problems with intake manifold pulsation's?

Paul Lamar


Tracy when it comes to intake design, I am following your advice to
Know My Own Limitations.  I had hoped to copy proven design,  such as
PowerSport's but also having a good look at what the racing guys have
done.   I have heard about the desirability of locating the  the
butterflies inside the rotor housing to improve throttle response.
Throttle response might still be good enough  if the butterflies are
located just outside of the housing.  Does anybody know?

Yes. That is not why Everett Hatch did it that way. It was
done to improve idle. We discussed this extensively awhile
back I guess before you were on the list.

snipped>>

Wasn't he using a mechanical fuel injector back then?  I've always suspected
that his idle problems were due to poor mixture distribution. Can anyone explain
why a properly set up electronic injector can't deliver a proper mixture to the
rotor chamber at idle even if the throttle body is in its 'conventional
location?

Charlie England

There is more overlap between the intake and exhaust ports when 
p-ports are used. The intake mixture is contaminated by exhaust 
gases at idle. That leads to misfire. 

Moving the throttle plates closer to the rotor 
reduces the volume in the intake runners subject to storing 
these exhaust gases. Everett explained this to me during one
of our many discussions. Also down load the Mazda side exhaust 
port tech paper on http://www.thecarricos.com/ACRE/

BTW Charlie please fix your calendar on your computer as it is a day off.
That mess's up my inbox.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.