I agree. Lynn, in a Van's RV-x with a fixed pitch prop, anything over about
700
> prop rpm will cause airliner like approaches & hundreds of feet of float
in
> ground effect. Can a p-port idle under 1500 with no danger of quitting
either on
> its on or with sudden throttle opening? I would consider *slight*
hesitation
> acceptable. Someone (was it you?) mentioned cutting the p-port to match
the side
> port timing. Shouldn't that solve the overlap problem Paul mentioned in
a
recent
> exchange about this issue?
>
> Charlie England
Charlie you are forgetting that Power Sport has been flying p-ports for
years in RV's. Allan Tolle has flown many times coast to coast and
entered several Sun & Fun races. No landing problems as far as
I could tell. Tracy Crook never idled his RV-4 engine below 1800
to 2000 engine RPM 829 to 922 prop RPM for years because the Ross
gear box would rattle mightily. He also does not slip when landing.
Paul Lamar
snips..
My answer was incomplete as usual. The reason the idle is set at 2,000
RPM is that at lower RPM the engine shakes the gear box so hard it sounds
like it will explode. While there are actually no torque reversals there are
some amazing accelerations and decelerations that are frightening. This
caused in the race car by the lack of rotating mass to damp out the power
pulses.
My Tilton flywheel is 5 1/4" diameter. The flexplate and damper in
the aircraft application is about the same weight. So if you have a gear type
speed reducer then you have the shaking /noise problem that is cured by
increasing the idle speed. Not a problem as many have pointed out. For the
record, the periphery port engine will idle down to 700 RPM without a
problem, (other than the gear noise). Now if you have a belt drive reducer
you might get the idle down close to street stock. It depends on the mass and
belt flex and a bunch of things. I would think that just for landings a much
lower idle speed could be arranged with an electric dashpot.
The car is loaded up and in the trailer ready for the SCCA National
championship races at Mid Ohio Sports Car Course at Mansfield Ohio. I built
up a fresh engine from all of the scrap pieces left after the last bearing
failure. It sounds crisp and sharp. I have been putting time on it in the
shop. No leaks and no air in the coolant after two runs to temp. Oil pressure
is 85 pounds at idle (2,000 RPM). I am out of Teflon wire and used Mazda
coolant "O" rings.
(I hope they work.) Just joking.
Lynn E. Hanover.
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.