> Hi, Paul....I have a 13B that was originally set up to run
plugs up. I wish to convert to normal
        > mounting (oil pan mount on order). I removed the oil pan that
another builder had constructed,
        > (see photo number one). and upon removal of the oil pan, found
the following (see photo number
        > two). My question is, what is missing (if anything) to convert
back to "pan down" mounting. It
        > appears that the pickup tube has been altered, so I'm sure I
need to replace that. Any other
        > problems evident to you? Finally,  best source for oil pan,
pick-up tube and pan mounting
        > bolts that are an extra 1/2 inch long to allow for the
mounting plate?  Thanks in advance for your
        > reply. Paul Conner, Mobile, AL
        >

        Hello Paul Conner,

        I am just now reading this post - I have an extra oil pan and
pickup that I can give you (yes, for free!).

        I will not be back in the country until Tracy's flyin and could
bring it to you there if you are attending.

        Ken Powell

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.