Hesitation is one thing but idle stability is another.
They are not really related.
Paul Lamar
If I understand correctly:
1) there is no problem with throttle response regardless of where
the throttle plates are located.
As far as I know this is a true statement. PL
2) As long as I can tap in between the rotor and the throttle
plates, the EC-2 will work.
I think so. PL
3) It appears that gear box shake is not related to Peripheral Ports
but happens below 2000 rpm regardless of intake configuration.
Also a true statement. However Tracy has amade a major advance
on this by doing away with the Ross clutch disk and replaced
it with a rubber bushing based torque isolator. As I recall it
will idle right down to 600-800 engine RPM or
280 to 370 prop RPM. Correct me if I am wrong Tracy.
4) If it were not for gear box shake, we could reduce the idle to
1000 engine rpm.
Yes. See above. PL
I still don't understand:
5) if "idle stability" is a serious problem? Or if it is related to
throttle location? Lynn has been running PPs for a long time and did
not even mention idle stability.
As I understand it was a serious problem for Everett Hatch but he was
not using EFI. He was using mechanical fuel injection. He improved
the idle stability by moving the throttle plates close to the rotor.
I drove a peripheral port NSU RO80 with a carb in Germany and I could
detect no idle problems. PL
) what's a "dash pot?"
A dash pot is like a car "shock absorber" only much smaller. PL
7)what effect does injector location have? It seems that putting the
injectors in front or behind the throttle plates would have some
effect.
Moving the injectors to the inlet ends of the intake runners
reduces fuel consumption slightly and makes the throttle response
worse. Moving them close to the rotor improves the throttle
response but increases the fuel consumption slightly. We are
talking fractions of a second about throttle response. This is
important in road racing but is totally irrelevant for aircraft use. PL
8)Can the injectors be placed on the cold side as was suggested on
this list some time ago.?
Yes. PL
9) How come my RX-7 idles smoothly at 1200 rpm and has no shake what-so-ever?
Heavy flywheel or torque converter. PL
My thanks to Paul, Tracy, Lynn, Charlie and Ed for the continuing
education. Jerry
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.