Subject: Rhino Monty13B
From: ACRE NL
Date: 9/16/2002, 10:26 AM


Hello Paul,
I had no problem with Monty's Rhino file.
Did you send this for some other reason like alloy end plates or
something else!
If this is the case we should make the end plates for peripheral ports as
they would be a lot easier without the ports in the sides.
Mounting could be through the front housing like a dynafocal
arrangement.
Could the reduction unit be driven off the front of the engine to a
modified E-shaft.

You would have E-shaft problems I suspect.

By the way Paul I have an oil pump that will handle 8000 rpm and
weights .94lbs for the PRSU lube, I can now run the best oil for this
application as long as it is not to heavy.

--
Best regards,
 ddunbar                          mailto:ddunbar@echidna.id.au

Somebody is working on the dynafocal idea.
It is possible to save about 30 pounds if the dynafocal casting
also incorporated the front end housing water jacket and
water pump housing. Front end housing would be milled down to about
3/16 inch thick to save the wear surface.

Everybody, what would it be worth to you to have an engine that
was 36 pounds lighter in weight and that would plug into a dynafocal
mount. How much would you pay?

Paul Lamar


If it will mount and work on a Single rotor I'd consider it.  $900 to $1200 would be my limit.

Tom Webber

 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.