Hesitation is one thing but idle stability is another.
They are not really related.
Paul Lamar
If I understand correctly:
1) there is no problem with throttle response regardless of where
the throttle plates are located.
As far as I know this is a true statement. PL
2) As long as I can tap in between the rotor and the throttle
plates, the EC-2 will work.
I think so. PL
3) It appears that gear box shake is not related to Peripheral Ports
but happens below 2000 rpm regardless of intake configuration.
Also a true statement. However Tracy has amade a major advance
on this by doing away with the Ross clutch disk and replaced
it with a rubber bushing based torque isolator. As I recall it
will idle right down to 600-800 engine RPM or
280 to 370 prop RPM. Correct me if I am wrong Tracy.
snips..
Paul Lamar
The EC2 should work with the tap below the throttle plates. The worst that
could happen is a small accumulator might be required to filter out
fluctuations in MAP at low rpm. A fuel filter in the MP line would be
plenty of volume.
There are many more reasons why I can idle smoothly down to 800 rpm, but
yes, this is true. At 800 rpm you can follow a prop blade around with your
eyes, it looks very slow.
I don't know if the PP engine will idle smoothly at that speed or not, too
many factors involved. I have never been around when the (new) Powersport
engine was idling slow so I can't comment on it. I watched them taxi by
once but the engine was going something like 1800 rpm. The early Powersport
engine (Airflow Performance mechanical fuel injection) sounded like an
engine with a radical race cam at idle, Rump___, Rump_____,
Rump____........ The Mazda Lemans racer (PP 26B engine) had the rattiest
idle I've ever heard. It was completely unusable for an aircraft.
Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.