Subject: Rhino Monty13B
From: ACRE NL
Date: 9/17/2002, 5:20 AM


Somebody is working on the dynafocal idea.
It is possible to save about 30 pounds if the dynafocal casting
also incorporated the front end housing water jacket and
water pump housing. Front end housing would be milled down to about
3/16 inch thick to save the wear surface.

Everybody, what would it be worth to you to have an engine that
was 36 pounds lighter in weight and that would plug into a dynafocal
mount. How much would you pay?

Paul Lamar


Paul,

  Cant remember if this was asked previously or not. How do you account for
the fact that with the most common PSRUs the prop turns backward relative
to a Lyc? I'm sure most kit manufacturers add thrust offset to their mounts
(Vans does) so the new front housing will need to offset the opposite way
to take this back out. Vans mounts also displace the mount points sideways
to correct for the offset angle so that the prop hub is on the centerline
of the airplane. The new housing would have to account for this as well.

Tracy says he does not notice it.

  Do all kitplane manufacturers use similar schemes with the same offset
angles? If not, then your new front cover isnt going to be as universal as
you'd like it to be. But if this were possible, sign me up. I think it
would be a great leap forward.

  I'll turn the cost issue back to you. What do you think such a cover
would have to sell for? I think the market would be pretty large. I have 2
friends right now who would be putting 13Bs on their airplanes but are
intimidated by the prospect of having to build a mount.

  I do agree with Charlie though, in saying that I think it would probably
be better if it were a conical style rather than a Dynafocal style. If
nothing else, conical rubber isolators are a fraction of the cost of
Dynafocals. I think most kit plane manufacturers offer both types of mounts
to their builders.

Mike Wills

For this sort of thing you have to have a ten year business plan
because of the cost of R&D, the small size of the market and
pattern cost. My guess is close to $2,000 - $3,000 initially.

Paul Lamar

Paul,

  Tracy built a mount with no offset (as did I based on Tracy's input).
Which is not the same as what your talking about. The stock mount for my RV
has offset going the wrong way for the Mazda/RD1 combo. I cant imagine that
this wouldnt be noticeable so have to believe that the new front housing
would at the least need to compensate to get everything back to a zero
thrust angle.

  I imagine $2000 - $3000 would be too much for most folks since it is
possible to have a custom mount welded up for far less. I'd think that
$1000 - $1500 would be marketable.

Mike Wills

This would be no problem at all if Tracy went to the 2.85:1 PSRU.
Prop rotates in right direction.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.