Subject: Sandwich plate between engine and oil pan.
From: ACRE NL
Date: 9/20/2002, 11:00 AM


 If you insist on using four motor mounts at the
 four corners of the engine and you are going to
make a
 new oil pan this is a much lighter weight and
much
 cheaper way of doing it. I call it the Schertz
 beam after the inventor Bill Schertz. The oil
pan
 must be designed accordingly of course.

 Bill, do you have another pic? The last one is
a bit out of focus.

 Paul Lamar


This one shows the other end of the beam, with the
engine sitting in place.
I will have to try to take another closeup of the
end with the oil cooler
outlet end to get a non-fuzzy one. I have to
borrow a digital camera, so may
be a couple of days.

Bill Schertz
KIS Cruiser #4045

Francois St-Germain wrote:

Hi Bill here is a plate that is designed to be inserted
between the engine and the oil pan.
The only thing that has to be done on the engine is to
oversized oil pan holes to 5/16 NF.

Hope you like it
Frank

What does it cost Frank? What does it weigh?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.