If you insist on using four motor mounts at the
four corners of the engine and you are going to make a
new oil pan this is a much lighter weight and much
cheaper way of doing it. I call it the Schertz
beam after the inventor Bill Schertz. The oil pan
must be designed accordingly of course.
Bill, do you have another pic? The last one is a bit out of focus.
Paul Lamar
This one shows the other end of the beam, withthe engine sitting in
place.
I will have to try to take another closeup of the end with the oil
cooler
outlet end to get a non-fuzzy one. I have to borrow a digital camera, so
may
be a couple of days.
Bill Schertz
KIS Cruiser #4045
Barry Gardner wrote:
Paul,
I think I remember that Bill Schertz lives in Batavia, IL, not far from me
in Wheaton, IL. Would you send him my name and phone number? He is certainly
welcome to borrow my digital camera if he needs one. I can run it over to
his house while I'm out on errands.
Barry Gardner
630-682-9225
barrygardner@mindspring.com
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.