Subject: Peripheral ports & EC2 use.
From: ACRE NL
Date: 9/21/2002, 3:57 AM


Charlie you are forgetting that Power Sport has been flying p-ports for
years in RV's. Allan Tolle has flown many times coast to coast and
entered several Sun & Fun races. No landing problems as far as
I could tell. Tracy Crook never idled his RV-4 engine below 1800
to 2000 engine RPM  829 to 922 prop RPM for years because the Ross
gear box would rattle mightily. He also does not slip when landing.

The port timing has little to do with the p-port overlap
problem. This is mainly due to the pocket in the
face of the rotor. That is the main avenue for the exhaust
gases to enter the fresh mixture area. That path is open from
the moment the apex seal passes the lower floor of the p-port
intake until the next apex seal passes the ceiling
of the p-port exhaust. Then the process soon begins again
with the next cycle. In other words it is open the majority
of the time. P-port intake timing has little to do with it.

When the pressures are the same there is no flow.
This delicate balance of pressures is the main
reason intake and exhaust pipe tuning is so critical
with p-ports. It is quite remarkable that Racing Beat
can build a turbocharged 3 rotor p-port engine developing
over 300 HP per rotor on gasoline.

If it can be done on a 3 rotor, then it could be done on a 2 rotor as well.
300 HP per rotor that is.
What is the known record for HP on a 2 rotor?
Royce

On alcohol and NOS about 800 HP.

That's about like firing the JATO bottles on a C-130.
You are right Paul, quite remarkable what Racing Beat is able to do.
Royce

Actually it was not Racing Beat. It was Abel Ibbarra from 
an East LA muffler shop :-) It was kind of an embarrassment
to Jim Mederer at Racing Beat. Abel has been dominating
import drag racing for the last four or five years. He does not
have to compete anymore. The organizers just pay him
big bucks to show up and make a few under 7 sec over 185 MPH runs.

Word is the rotor face collapsing is now the limit if you keep 
the RPM under 11,000 at launch. As I said on here awhile back 
somebody needs to figure out how to make a rotor of high 
strength high temp material rather than cast iron. I think 
it could be done if the rotor was first machined and then 
laser welded together on the center line.
 
Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.