Subject: 20B overhaul questions
From: ACRE NL
Date: 9/22/2002, 7:43 PM


Correct, there is no thermal bypass valve in the 20B.
As far as the oil jet mod, just be sure that you know exactly why
you are
making the change.  Just because the car racers do it is not a good
reason
to make a change.  If you do the oil jet change, the 13B size should
be good
for the 20B too.

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com

Tracy,


          Did Bruce T. incorporate oil jet mod to your 20B and how does
he stand
 on the necessity of it?

        Kelly Troyer

No change to the cooling jets on my 20B.  My take on it is that unless you
are pushing the limits of the engine, the stock setup is OK.  Increasing the
oil flow when you don't need it only decreases the efficiency of the engine.
I'm aiming for 270 HP, well below the stock rating of the engine.

I wanted to run the rotor as hot as possible (for efficiency) without
pushing the temperature limits of the oil control O-rings.  I have had no
problem with deterioration of the O-rings, even the stock Mazda ones.  My
20B has Viton rings.  I am awaiting the results of some testing on an engine
with the TES O-rings.  These may be even better.  In which case, there is
even less reason to increase the flow of rotor cooling jets.

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com


 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.