Fred Vandeman wrote:
I'm using the Turrentine video and it would appear that the 20B does not
have/use the oil bypass thermostat??? Or is it in a different location
than under the front eccentric shaft bolt?
One more.......I want to bypass the eccentric rotar oil check ball and
spring. Do I want to use the same size Weber jet (#200) as the tape
suggest for the 13B ?
Thanks
Fred
Correct, there is no thermal bypass valve in the 20B.
As far as the oil jet mod, just be sure that you know exactly why you are
making the change. Just because the car racers do it is not a good reason
to make a change. If you do the oil jet change, the 13B size should be good
for the 20B too.
Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com
Fred Vandeman wrote:
I have two reasons: 1. Relative high RPM for prolonged periods for aircraft use. I want to keep
the rotars running cooler. 2. Since cooling is one of the significant problems to
solve.......the faster I can remove heat from the engine.....the less I may encounter problem on
the ramp on hot days.
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.