Hello Paul,
I have been looking at getting my engine mount at or in front of the
CG.
I have attached a Auto-cad 12 DXF file for you to look at.
This new arrangement lets me use the standard exhaust manifold and
turbo.
It also makes the 20mm pipes wider apart to house a wider radiator.
All the material I have in stock of offsets.

--
Best regards,
 ddunbar                          mailto:ddunbar@echidna.id.au

AN> Looks good with a few minor mods as shown.
AN> I like that aluminum plate T Schertz Beam.
AN> A channel version would give you room underneath for a tube tying the two
AN> rubber bushing holders together. Than a simple diagonal tube
AN> would suffice for lateral bracing instead of a big X brace.
AN> Keep the bottom of the oil pan as small as possible to minimize
AN> radiator blockage.

AN> Mock it up and make sure the stock turbo fits. In my case the the rubber
AN> bushing holders had to be 29 inches apart. Your firewall
AN> mounting points may be further apart than mine giving you more
AN> room for the motor mount tubes.

AN> Paul Lamar

Thank you for the quick response to my mount design.
At the moment I am 25 mm in front of the CG of the engine and PRSU, if
I go any further forward the standard boost regulator will hit the
20mm tube mount.

I would like achieve more bolts through the T bar flange as your
drawing and will have a look at this and see how wide I will need to
make the rubber mounts. The extra bolts is not that important as I
will weld the flange of the T bar transverse only to the sump 4 mm
plate.
I have some 40x40x3 Box section that would do the job but I than can't
get the bolts into the sump plate with this.

--
Best regards,
 ddunbar                            mailto:ddunbar@echidna.id.au

Well it might drain back OK with it further back.
The drawback to the box section is all the spacers that need to 
be welded in. I really like your T Schertz Beam better. No spacers
needed. The drawback is it takes a big tig welder or preheating
to weld it. No problem for you of course.

I added a couple of inches to the width of the beam in the rendering.
I will have to model that stock waste gate regulator.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.