Fred Vandeman wrote:
I'm using the Turrentine video and it would appear that the 20B
does not
have/use the oil bypass thermostat??? Or is it in a different
location
than under the front eccentric shaft bolt?
One more.......I want to bypass the eccentric rotar oil check
ball and
spring. Do I want to use the same size Weber jet (#200) as the
tape
suggest for the 13B ?
Thanks
Fred
Correct, there is no thermal bypass valve in the 20B.
As far as the oil jet mod, just be sure that you know exactly why you
are
making the change. Just because the car racers do it is not a good
reason
to make a change. If you do the oil jet change, the 13B size should
be good
for the 20B too.
Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com
Fred Vandeman wrote:
I have two reasons: 1. Relative high RPM for prolonged periods for
aircraft use. I want to keep
the rotars running cooler. 2. Since cooling is one of the significant
problems to
solve.......the faster I can remove heat from the engine.....the less I
may encounter problem on
the ramp on hot days.
Note that both of your factors will be somewhat counterproductive to
cooling. These factors will increase the cooling load for the cooling
system. The higher the differential between the combustion gasses and the
surface of the rotor, the higher the percentage of combustion energy lost
into the face of the rotor. Car makers have been increasing the cooling
system temperature over the last 40 years for the same reason.
On the ramp (at idle ot taxi speed) is the last place you will have a
problem with rotor cooling.
Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com
Fred Vandeman wrote:
I think I'm bagging the thought of removing the check ball. Thankes fred
You will get higher oil pressure at hot idle if you leave it in.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.