Just a thought from someone who has not had a chance to work on a
Wankel, if
you are trying to keep heat out of the rotor, have you tried the cermet
coatings used on piston tops. The racers use these coatings to keep the
heat in the exhaust, and the I've had good results using them on an old
flathead to keep the load off the cooling system. I've coated the
combustion chamber side of the head, piston tops, and combustion chamber
side of the valves.
There are also metal spray coatings that would work that are used on
turbine
engine parts, but these are much more dificalt to apply, and much more
expensive.
Rick Diekman
I believe Ken Welter has done this to his 13B with good results. He makes
a lot of horsepower with Nitrous Oxide albeit intermittently. Ken?
Mike McGee, RV-4 N996RV, O320-E2G, Hillsboro, OR
13B in gestation mode
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2002 All world wide rights reserved.