Subject: 20B overhaul questions
From: ACRE NL
Date: 9/24/2002, 11:59 AM


Fred Vandeman wrote:




 I'm using the Turrentine video and it would appear that
the 20B


does not


 have/use the oil bypass thermostat???  Or is it in a
different


location


 than under the front eccentric shaft bolt?

 One more.......I want to bypass the eccentric rotar oil
check


ball and


 spring.   Do I want to use the same size Weber jet (#200)
as the


tape


 suggest for the 13B ?

 Thanks
 Fred





 Correct, there is no thermal bypass valve in the 20B.
 As far as the oil jet mod, just be sure that you know exactly
why you


are


 making the change.  Just because the car racers do it is not a
good


reason


 to make a change.  If you do the oil jet change, the 13B size
should


be good


 for the 20B too.

 Tracy Crook
 tcrook@rotaryaviation.com
 www.rotaryaviation.com

Fred Vandeman wrote:


 I have two reasons:  1. Relative high RPM for prolonged periods
for


aircraft use.  I want to keep


 the rotars running cooler.   2. Since cooling is one of the
significant


problems to


 solve.......the faster I can remove heat from the engine.....the
less I


may encounter problem on


 the ramp on hot days.


Note that both of your factors will be somewhat counterproductive to
cooling.  These factors will increase the cooling load for the
cooling
system.  The higher the differential between the combustion gasses
and the
surface of the rotor, the higher the percentage of combustion energy
lost
into the face of the rotor.   Car makers have been increasing the
cooling
system temperature over the last 40 years for the same reason.

On the ramp (at idle ot taxi speed) is the last place you will have a
problem with rotor cooling.

Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com


Fred Vandeman wrote:

I think I'm bagging the thought of removing the check ball.   Thankes
fred


You will get higher oil pressure at hot idle if you leave it in.

Paul Lamar


Just a thought from someone who has not had a chance to work on a Wankel, if
you are trying to keep heat out of the rotor, have you tried the cermet
coatings used on piston tops.   The racers use these coatings to keep the
heat in the exhaust, and the I've had good results using them on an old
flathead to keep the load off the cooling system.  I've coated the
combustion chamber side of the head, piston tops, and combustion chamber
side of the valves.

There are also metal spray coatings that would work that are used on turbine
engine parts, but these are much more dificalt to apply, and much more
expensive.

Rick Diekman


 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.