Subject: 20B overhaul questions
From: ACRE NL
Date: 9/25/2002, 7:54 AM


snip
Fred Vandeman wrote:

I think I'm bagging the thought of removing the check ball.   Thankes
fred


You will get higher oil pressure at hot idle if you leave it in.

Paul Lamar


Just a thought from someone who has not had a chance to work on a Wankel,
if
you are trying to keep heat out of the rotor, have you tried the cermet
coatings used on piston tops.   The racers use these coatings to keep the
heat in the exhaust, and the I've had good results using them on an old
flathead to keep the load off the cooling system.  I've coated the
combustion chamber side of the head, piston tops, and combustion chamber
side of the valves.

There are also metal spray coatings that would work that are used on
turbine
engine parts, but these are much more dificalt to apply, and much more
expensive.

Rick Diekman


Hey Rick, I am currently coating my motor. I have had extensive experience
with these coatings in
many engines. So far the 13B Turbo motor will be together in about 3 weeks for
break in. Once it
is broken in I will finish the coating of parts and dyno testing will begin. I
am currently using
Techline coatings except on the rotor faces. I used Techlines' CBX pretty
religiously but found a
new coating for the rotor faces from a different manufacturer that does not
have any aluminum in
the coating nor does it have any ceramic. It lowers the heat retention. It
sprays thinner and
there is no clearance problems with the materials. I will keep all informed!



       Who is the masked man who posted this?

     Kelly Troyer


 
The AirCraft Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2002 All world wide rights reserved.